Most of our
products are a unique combination of mechanics, electronics,
optics and software, in one word
'Mechatronics'.
We
robotize and automate manual systems to increase production,
decrease the operational cost making it easier to control
processes
|
| |
HemoForm®
HemoForm®
is a specially prepared Silicon Paste for capillary withdrawal
of blood.
HemoForm® induces the formation of large droplets of
blood that can be collected by capillary means or as desired.
Read
more about it...
|
 |
| |
|
|
| |
Inte liner
V8
InteRRliner
makes continue production of the ESR analyses available,
as stand-alone or as a segment within an complete production
line. Easy loading of the samples from the racks into the
machine. Full automatic barcode reading for an optimum co-operation
with the administration- and report software. Fully automated
preparation of samples before aspiration.
Read
more about it...
Return
to toppage
|
 |
| |
|
|
| |
Stased
Auto Compact analyzer
Based on
the established StaRRsed
Compact, the addition of the StaRRsed
Rack now provides what the busy Hematology Lab has been demanding,
the StaRRsed
Auto Compact. Using existing blood cell counter racks, the
operator time is reduced to nearly zero. Results are available
in either one-hour or half-hour mode with an hourly capacity
of up to 135 samples. The StaRRsed
Auto Compact takes ESR sampling to new heights.
Read
more about it...
Return
to toppage
|
 |
| |
|
|
| |
Stased
Inversa
24M
The StaRRsed
Inversa 24M, the small footprint
Westergren ESR solution. Manually loading up to 24 samples
and performing the ESR fully unattended. Only two reagents
needed, for dilluting and cleaning, located inside the instrument.
Built-in chip card for easy pay per test use, a built-in
printer and simple automated cleaning procedures make this
instrument the appropriate instrument for small labs.
Suitable for labs doing up to 100 ESR-samples per day.
Read
more about it...
Return
to toppage
|
 |
| |
|
|
| |
Stased
Compact analyzer
The StaRRsed
Compact is our latest type ESR (Erythrocyte Sedimentation
Rate) analyzer, based on the functions of earlier models
of StaRRsed.
It produces a true Westergren result and conforms to the
recommendations of the International Council for Standardization
in Hematology (ICSH).
Read
more about it...
Return
to toppage
|
 |
| |
|
|
| |
L@SSIST
LIMS in the new
dimension
Over more
than 16 years of sound knowledge and a vast experience is
combined in a perfect LIMS system that will astonish many
clinical analyst, medical specialist and system manager.
The L@SSIST
system manages and controls the data stream, both requests
and results, in and outside the laboratory, including agenda
and on request paperless with a completely electronic archive.
L@SSIST communicates through RS232, TCP/IP or HL7 with many
different automated analyzers, external information systems
and electronic patient file archive systems to manage the
incoming stream of requests and results. The transparent
interfacing with the Electronic Patient File System (EPFS)
makes L@SSIST to be considered as a true building stone for
that system without the overhead of inventing and developing
solutions again and again.
Read
more about it...
Return
to toppage
|
 |
| |
|
|
| |
Aimonia
The AiRRmonia
analyzer contains a membrane sampler for quantitative sampling
of gas-phase ammonia. After diffusion through the membrane
the ammonia is absorbed in a sampling solution. Ammonium-containing
aerosols pass the sampler. The sample solution is pumped
continuously through the detector for conductivity measurement
after elective membrane diffusion.
Read
more about it...
Return
to toppage
|
 |
| |
|
|
| |
FLOIA
The automated
analyser for measuring low concentrations of ammonium in
water. The FloRRia can hold as much as 100 sample tubes at
a time performing the analyses unattended.
Only a NaOH-solution and demi-water is needed to perform
analyses. Sample rate is approx. 12 samples per hour. Concentrations
of 5 ppb (minimum) to 30.000 ppb (maximum) may be measured.
Interfacing through RS-232 to a host computer running easy-to-use
dedicated software enabling calibration, operation, setup,
control and archiving.
Read
more about it...
Return
to toppage
|
|
| |
|
|
| |
Loca
MaxSis Osmoscan
The LoRRca
MaxSis Osmoscan is a new extended version of its predecessor
Lorca II.
LORRca stands for Laser Optical Rotational
Red Cell Analyser.
This unique
instrument is capable of fully automated control, measurement
and calculation of various phenomena of Red Blood Cells (Erythrocytes),
such as Deformability, pre-haemolytic Stability and Aggregation.
Typical application fields are haema-rheological studies
(cell mechanics, Relation to blood viscosity and effect of
medication) Blood banking (pre-haemolytic cell damage control)
and clinical diagnostic & therapeutic studies (haemolytic
anaemia, malaria tropica, sickle cell disease and sepsis)
All is incorporated in this versatile instrument that comes
with a unique application program for automation of the tests,
calculation and presenting the data.
Read
more about it...
Return
to toppage
|
|
| |
|
|
| |
Intecom
The InteRRcom
let's you communicate in different applications, where special
data input and output is needed. The device can, for example,
be used to read and pass barcodes to analyzers without barcode
facilities. The InteRRcom
is a efficient solution to get use of facilities within analyzers
without changing the existing methods of workflow.
Read
more about it...
Return
to toppage
|
 |
| |
|
|
| |
Stacol
The StaRRcol
is a micro-processor controlled filter photometer for the
measurement of sample concentrations in a homogeneous solution.
Due to application of microprocessor controlled electronics
and high quality K�hler optics, the StaRRcol
is very easy to operate and highly reliable. Both low and
high range absorptions can be measured with great accuracy.
Read
more about it...
Return
to toppage
|
 |
